Muc-Off MTB Tubeless Mountain Bike Sealant 80ml

• Remove all old rim strip or tape and clean rim.
• Make sure the rim is clean and dry before applying tape.
• Get the tape from the packet and line it up from the opposite side of the valve.
• Start by unwinding a small amount of the tape and pressing it down using your thumb or finger to hold pressure down.
• Continue to hold while you pull back on the tape and stick down tight once you have a few cm on the tape will stick and holding is no longer needed.
• Continue the entire way around the rim (if it has a big concave in you can pull and wiggle the tape to fill any edges)
• Overlap the tape by roughly 10 – 15cm
• Leave a small amount unstuck so that you can cut the remainder off
• Once cut sketch and pull the tape down to create a seal
• Go around the rim with your thumb to make sure there is no air pockets or messed areas.
• Once your happy with how it looks using a small pin locate the valve hole and cleanly pierce the tape ready for the valve
• Grab your tubeless valve and remove the lock ring and o ring
• Chose the right rubber fitment for your rim tape and insert valve into rim
• Refit O-ring and Lock ring making sure you lock the valve in (don’t go to tight or could damage the rubber)
• Re-fit your tyre of choice carful not to damage the tape (by using tyre levers ect)
• Inflate tyre to create a fit (should hear some popping around the rim)
• Release Air and remove valve core using the spare valve cap
• Grab the sealant pouch and give it a shake
• Unscrew the cap and fit on the valve in a up right position
• While holding the pouch spin the wheel downward so that the pouch is now upside down
• Insert the sealant by rolling the pouch down
• Spin wheel back up right and remove pouch
• Reinsert valve core and inflate to your pressure

• Keep out of reach of children.
• Dispose of contents/container in accordance with local regulations.
• Avoid contact with eyes.
• Do not drink.

How to Clean Sealant Off Your Kit:

All tyre sealants can stain. If No Puncture Hassle Tubeless Sealant sprays on your kit out on the trail, immediately rinse the affected area with clean water from your bottle and wipe off with a damp cloth as soon as possible. Key Tip: Avoid letting the sealant dry before you can properly wash your kit at home.

Once home, rinse the area with clean water, then use a pre-wash product (ensure fabric compatibility first) before washing your kit in the machine with a good laundry detergent. Alternatively, hand wash with a quality liquid cleaner as soon as possible. (Always follow the manufacturer’s washing instructions).

Minimum amount per tyre:

(add up to 30ml extra for increased protection)

• 26" MTB & 27.5": 60-75ml (4 to 5 scoops)
• Cross 700c: 60-75ml (4 to 5 scoops)
• 29" MTB: 105ml-140ml (7 or the whole pouch)
• Downhill: 120-140ml (8 or the whole pouch)

*If using in extreme heat (+35°C) simply top up if needed.